Description
Infinite Repeat Floral Scroll Leather Stamp Mold
This single-sided leather stamp features a narrow Western floral scroll pattern with flowing leaves and decorative flowers.
The pattern is designed to connect continuously from end to end, allowing you to repeat the impression and create a longer embossed design for belts, straps and other narrow leather projects.
Important — Equipment Required
A hydraulic press and a soft silicone pad are recommended to achieve the embossed result shown in the photos.
An electric hydraulic press of approximately 8–10 tons is recommended. However, every press machine, leather thickness, moisture level and leather temper behaves differently.
Please always test the pressure, moisture level and pressing time on a scrap piece of leather before embossing your finished project.
How To Use
1. Lightly spray or evenly dampen the vegetable-tanned leather.
2. Secure the mold firmly in the centre of the hydraulic press.
3. Carefully position the leather over the engraved surface.
4. Place a soft silicone pad behind the leather so that the leather sits between the mold and silicone pad.
5. Apply pressure gradually and evenly.
6. For a continuous pattern, carefully align the beginning of the next impression with the end of the previous section before pressing again.
Accurate alignment, even pressure and consistent leather moisture will help create a smooth and natural connection between repeated sections.
Product Details
- Design: Western floral scroll and leaf pattern
- Mold type: Single-sided leather stamp mold
- Pattern type: Continuously repeatable
- Mold size: Approximately 135.5 × 24 mm
- Measurements are taken manually and may vary slightly
- Material: 2A12 super duralumin
- Suitable for vegetable-tanned leather
- Designed for use with a hydraulic press
- Suitable for narrow belts, straps and decorative leather borders
Leather Recommendation
- Vegetable-tanned leather is recommended.
- Leather approximately 2.5 mm or thicker normally produces the clearest impression.
- For thinner leather, a soft silicone pad is especially important to help the leather conform to the engraved details.
- The leather strip should be slightly wider than the 24 mm mold width.
- Please measure your leather project carefully before ordering.
Suitable For
- Leather belts
- Bag straps
- Shoulder straps
- Guitar straps
- Leather borders
- Decorative leather panels
- Western leathercraft projects
- Handmade leather accessories
Package Includes
- One 2A12 aluminum leather stamp mold
Leather pieces, silicone pads, hydraulic presses and other tools shown in the photos are not included.
Please Note
- Photos of embossed leather are sample results used to demonstrate the pattern.
- Leather colour, finishing and surface texture are not included with the mold.
- Slight machining marks may be present on the sides or back of the mold and do not affect normal use.
- Final embossing results depend on leather thickness, moisture, pressure, pressing time, alignment and machine performance.
Production & Shipping
Made to order. Production takes 1–2 weeks before shipment. Delivery time after dispatch depends on the destination.
For EU delivery, each order must not exceed €150. Please place separate orders within this limit.
Planning a belt or repeating pattern? Watch the belt stamp alignment and repeat-pattern tutorial alongside your mold’s individual setup notes.
Reviews
There are no reviews yet.