Repeatable Floral Belt Stamp Mold – 224 × 30 mm

Description

Handmade 2A12 aluminum leather embossing mold with a continuous floral scroll pattern, designed for repeating belt and strap work.

Important Use Notes

• This is an infinite extension / continuous pattern leather embossing mold.
• Please make sure you understand how to align the pattern before purchasing.
• For best results, vegetable-tanned leather is recommended.
• A soft silicone pad is strongly recommended during embossing.
• An electric hydraulic press is recommended.
• Suggested pressure: about 8–10 tons, but different machines, leather thicknesses, moisture levels, and leather characteristics will give different results.
• Please always test on scrap leather before working on your final project.

How To Use

1. Lightly spray the vegetable-tanned leather with clean water until the surface is evenly damp. Do not completely soak the leather.

2. Secure the mold firmly in the center of the hydraulic press and make sure it remains flat and stable.

3. Place a soft silicone pad underneath the leather to provide support and help the leather conform to the detailed relief.

4. Position the damp leather carefully over the silicone pad, then check that the mold, leather, and pad are properly aligned and centered.

5. Adjust the pressure before making the final impression. Start with lower pressure and increase it gradually until the desired embossing depth is achieved.

6. An 8–10 ton electric hydraulic press is recommended. However, different machines, leather thicknesses, moisture levels, and leather characteristics may require different pressure settings.

7. Always test the pressure, moisture level, and positioning on a scrap piece of leather before embossing your final project.

8. For a continuous pattern, carefully align the beginning of the mold with the end of the previous impression.

9. Check the connection point before applying full pressure to reduce visible gaps, overlaps, or misalignment.

Product Details

Material: 2A12 aluminum
Mold type: Single-piece embossing mold
Pattern style: Continuous floral / scroll pattern
Mold size: 224 x 30 mm
Use: Leather belt, strap, long panel, and repeating border embossing

Please Note

• This listing is for the aluminum mold only. Leather pieces shown in the photos are for display purposes only.
• Because each machine and leather type behaves differently, final embossing depth may vary.
• Handmade molds may have minor tool marks that do not affect normal use.
• If you have questions about machine suitability or how to use the mold, feel free to message me before placing your order.

Ideal For

• Leather belts
• Strap projects
• Repeating floral borders
• Vegetable-tanned leather craft
• Custom leatherwork

Production & Shipping

Made to order. Production takes 1–2 weeks before shipment. Delivery time after dispatch depends on the destination.

For EU delivery, each order must not exceed €150. Please place separate orders within this limit.

Planning a belt or repeating pattern? Watch the belt stamp alignment and repeat-pattern tutorial alongside your mold’s individual setup notes.