Leather Stamp Small three-dimensional skull convex leather shaping mold Skull leather mold - new type

Leather Stamp Small three-dimensional skull convex leather shaping mold Skull leather mold

Size:
- 104mm*59mm (Made with 15mm 2A12 Super duralumin)

Material: 2A12 super duralumin Mold

Attention: Suitable for a thickness of 2.5mm or above (Leather below 2.5mm needs to be used with silicone pads, not equipped with silicone pads)

Reference cutting line depth 1mm

This mold needs to be used with a press, and the effect is related to the pressure (Normally 10 tons)

The solution to the problem that the pattern with good plasticity cannot be bent twice:
Predetermine the deformation amount and use the software to calculate the required bending arc into the model, so as to achieve the three-dimensional effect after bending. In this way, the pressed leather pattern can be bent again after pressing to achieve the desired three-dimensional effect

More discount events on the Facebook page
Facebook Group: https://bit.ly/3UlOT7B
Facebook Page: https://bit.ly/3SmheJk
The picture shows the effect of the hydraulic press